And the carbureting method, raw material requirement, key operation parameters ect.
介绍了蓄热式催化裂解轻油制气的工艺流程、工艺设计参数和操作指标 ,探讨了轻油制气的增热方式、原料要求、关键操作参数等问
This paper introduces the technology of carbureting low calirific value gas with LPG.
介绍了丹东市液化石油气增热低热值煤气的生产工艺 ,运行实践表明 ,以此替代油制气与水煤气的混合气作为城市煤气是可行
Driving forces of hydrocarbon expulsion from carbonate source rocks are mainly hydrothermal pressurization and hydrocarbon generation pressurization due to the early diagenesis-consolidation of carbonates.
碳酸盐岩由于成岩-固结早,烃源岩排烃的动力主要是水热增压和生烃增压。
We redoubled our efforts [zeal].
我们加倍努力 [倍增热忱] 。
glass reinforced thermoplastic molding
玻璃增强的热塑模制品
carbon fibre reinforced thermoplastic
碳纤维增强热塑性塑料
glass reinforced thermoplastics
玻璃丝增强热塑塑料
fibre reinforced thermoplasticity plastics
纤维增强热塑性塑料
Card-carrying fitness enthusiasts.
热衷于增强体质的人
flame retardant RTP
阻燃性增强热塑性塑料
But turning up the heat increases the manufacturer's energy bill.
不过增添热量却要增加生产厂的能耗。
Modification of Increasing Heat Delivery Surface Area of Low temperature Reheater in DG1004t/h Boiler
DG1004t/h锅炉增加低温再热器受热面改造
INSTALL WATER HEATING MEDIA SYSTEM TO INCREASE HEAT EFFICIENCY OF COKING HEATER
增设水热媒系统 回收焦化加热炉烟气余热
There is a increase in heat radiation with a increase in load, and there is a decrease with an increase in speed.
负荷增加时辐射热量增加,转速增加时辐射热量减少。
The hot temperature difference and adiabatic efficiency increased by increasing cold air fraction,but cold temperature difference decreased.
冷流比增加,涡流板制热效应和绝热效率增加,而制冷效应下降.
The coefficient of convection heat transfer increases with increasing the particle diameters.
对流换热系数随着颗粒直径的增大而增大。
Analysis on Toughening Mechanisms of Different SiC Particle Reinforced Thermal Protective Ceramics
几种SiC颗粒增韧防热陶瓷的增韧机制分析
THE PRINCIPLE OF HEAT TRANSFER AUGMENTATION BY INTERFACIAL VAPORIZATION HEAT SINK AND ITS APPLICATIONS
界面汽化热阱增强传热的原理及其应用
fiber glass reinforced thermoplastics
玻璃纤维增强热塑性塑料, 热塑性玻璃钢
Probably Existed Enhanced Geothermal System in Taizhou Area of Jiangsu Province
江苏泰州地区可能存在增强型地热系统(干热岩)
Performance Evaluation of Total Entropy Increase Flower Baffle Heat Exchanger and Single Segmental Baffle Heat Exchanger
花板换热器及折流板换热器总熵增率性能评价