For the two-layer quasi-geostrophic flow on β plane,there is a minimum enstrophy if the energy,momentum and circulation are specified.
研究β平面上2层的准地转流,通过变分计算得出在给定能量、动量以及环量的约束条件下最小的拟能解。
nonlinear stability theorem analogous To arnold′s second stability theorem is established for a quasi-geostrophic flow with general boundary conditions in a periodic channel.
建立了周期域上准地转流在一般的边界条件下对应于 Arnold第二定理的非线性稳定性定理 。
Nonlinear Stability of Quasi-Geostrophic Flow;
地球流体准地转运动的非线性稳定性原理
eddy transfer of the sensible beat is closely related to the transfer of the momentum in the large-scale quasi-geostrophic motion.
在准地转运动中,大尺度涡动输送可分解为平衡输送和不平衡输送.
The sports field is marked out for an athletic meeting.
准备开运动会的运动场地已被划好。
35 Loading Port & Destination:From with transhipment and partial shipments allowed.
装运口岸和目的地准许分批与转船。
a piece of thick padding up on the floor for gymnastic sports.
地板上为体操运动准备的厚填料。
A Theory Analysis of Transformation of Sports under the Standards of New Courses
新课程标准下的竞技运动素材转化的理论研究
Study of the Time-Space Bench Transformation of Mars Probe Orbital Motion Modeling
火星探测器轨道运动建模的时空基准转换研究
The Survey and Design of the Base Stations in Tianjin Crustal Movement Observation Network
天津地区地壳运动观测网络GPS基准站的勘选
not moving or operating freely.
不能自由地运转或移动的。
YY Series motor is single-phase capacitor running asynchronous motor, meets related stipulations of IEC standard.
YY系列电动机是单相电容运转异步电动机，符合IEC标准的有关规定。
I called to her, and the mast moved easily and accurately.
我喊她一声，桅杆就很容易很准确地转动。
the state of being in good working order and ready for operation.
准备工作或运转的状态。
cause to move or operate freely within a bounded space, as of machinery.
造成有节奏地，自由地移动或者运转，关于机器。
Status quo and development scope of standard golf courses in China;
我国标准高尔夫运动场地现状及发展规模研究
CARRYING OUT PERMISSION TRANSPORT CERTIFICATION INSTITUTION OF MINERAL PRODUCTS AND COMPLETE PROMOTING ADMINISTRATION WORK OF GEOLOGY AND MINERAL RESOURCES;
实行矿产品准运证制度全面推动地矿行政工作
Analysis on vertical crustal motion of China based on datum of the GPS fiducial station
利用GPS基准站数据浅析我国地壳垂直运动
Research on vertical benchmark of crustal motion with ICE-4G
以ICE-4G模型为地壳垂直运动基准的研究
Pay attention to the turning direction of the milling cutter and the heading direction of the work table. Counter mill only usually.
注意铣刀转向及工作台运动方向，一般只准使用逆铣法。