Contact analysis of MW wind turbine hub and bearing bolt connection
风力机轮毂和轴承螺栓联接接触分析
The Fracture Failure Analysis on Main Bearing Bolts of the Diesel Engine and Investigation on Its Loading Behaviours;
柴油机主轴承螺栓断裂及其承载力学行为的研究
Bolt( screw, nut, stud, spring washer, pin, ball bearing, roller bearing) is the most commonly used machine part.
螺栓（钉、帽、头螺栓、簧垫圈、、珠轴承、柱轴承）最常用的机械零件。
377 bolt (screw, nut, stud, spring washer, pin, ball bearing, roller bearing) is the most commonly used machine part.
螺栓（螺钉、螺帽、双头螺栓、弹簧垫圈、销、滚珠轴承、滚柱轴承）是最常用的机械零件。
Install differential case and dummy bearings in axle housing (without shims) and tighten retaining cap bolts.
在轴壳内（没有垫片）安装差速箱和模型轴承，并紧固固定帽螺栓。
hydrauliccone-bolt coupling
液力锥形螺栓联轴器
Research and Design on the Backpressure Device and Bolt Assembly System in the Fracture Splitting Equipment of Main Bearing Walls on an Engine Block;
缸体主轴承座裂解加工背压装置及螺栓装配系统研制
Research and Design on Automatic Assembling Bolts System for Fracture Splitting Crankcase Bearing Block of Engine;
裂解发动机箱体主轴承座螺栓装配系统研究与设计
Plain Bearing Block Housings are made up of cap, base ,aluminum bronze bushing and installing bolts, which mainly bear radial load.
滑动轴承座由上盖、底座、剖分轴瓦（铝青铜），安装螺栓组成，主要承受径向载荷。
Remove nuts, U-bolts and spring bracket from axle.
由车轴拆下螺帽，U型螺栓和弹簧支架。
Front Stub Axle To Hub Bearing Nut
前螺桩轴至轮毂轴承螺帽
Research on the Influences of Internal Oblique Nut on Bolt Bearing Capacity
内斜螺母对螺栓承载能力影响的研究
spring seat bearing adjusting nut
弹簧座轴承调整螺母
wheel hub bearing adjusting nut
车轮毂轴承调整螺母
Lock rings at the end of shaft with bolt
GB/T892-1986螺栓紧固轴端挡圈
Bushing Retainer To Axle Attaching Bolts
衬套扣环与车轴接合螺栓
Remove vibration damper bolt and washer from end of crankshaft.
从曲轴端拆下减震器螺栓和垫圈。
Tie Rod End Adjusting Sleeve Nut
转向拉杆端调整轴筒螺栓