Spherical plain bearing rod ends-Boundary dimensions and tolerances
GB/T4222-1991杆端关节轴承外形尺寸和公差
Spherical plain bearing rod ends-Boundary dimensions
GB/T9161-1988杆端关节轴承外形尺寸
Study and Exploitation of the Parametric 3 Demension CAD System of Miniatur Rod End Ball Bearing;
杆端关节轴承三维参数化计算机辅助设计与研究
Before performing this procedure, the worm bearing preload adjustment must be performe
进行本程序之前，必须调节螺杆轴承的预应力。
Experimental research on load capacity of the bearing joints in Chinese Navigation Museum
中国航海博物馆关节轴承节点承载力试验研究
"The four arms of the spider, known as trunnions, are assembled into bearings in the ends of the two shaft yokes."
万向节十字轴的四个轴颈叫做万向节十字头,分别装在两个万向节叉顶端的轴承中。
Tie Rod End To Steering Knuckle Nut
转向拉杆端与转向关节螺栓
" Spherical plain radial bearings, joint type-Redial internal clearance"
GB/T12278-1990向心关节轴承径向游隙
" Spherical plain bearings, joint type-Abutment and fillet dimensions"
GB/T12765-1991关节轴承安装尺寸
" Spherical plain radial bearings, joint type-Boundary dimensions"
GB/T9163-1990向心关节轴承外形尺寸
Spherical plain bearings Identification code
GB/T304.2-1988关节轴承代号方法
Spherical plain thrust bearings-Boundary dimensions
GB/T9162-1990推力关节轴承外形尺寸
Angular contact spherical plain bearings-Boundary dimensions
GB/T9164-1990角接触关节轴承外形尺寸
An Improved Design on Seal Groove and Seal Ring of Spherical Plain Bearing
关节轴承密封槽及密封圈的设计改进
The main bearing journals fit into the cylinder block and the big end journals align with the connecting rods.
主要轴承曲颈安装在气缸体和与连杆大头末端匹配的曲颈上。
The Research of Key Technologies about Axial Bearing Ability in ESPCP System
潜油螺杆泵采油系统轴向承载关键技术研究
feeder drive link bearing
进料器的传动连杆轴承
connecting rod bearing pouring
连杆轴承巴氏合金浇注