The structural characteristics of gear cover plate of locomotive are analyzed.
分析了机车齿轮罩罩板的结构特点,介绍了该类模具的结构和工作过程,通过经济性分析提出通用性改进,对同类压型模具的设计有参考价值。
The technological process for bending the four edges of the cover plate with clips is analyzed.
对带卡筋罩板零件的弯曲工艺进行了分析 ,决定采用具有四棱锥台及活动弯曲凸模的四边弯曲模进行弯曲成形,介绍了弯曲模的结构特点及工作过程。
Carefully pull out and remove lamp housing
轻轻拉起并取下灯罩板
Position the quarter panel trim extension on the wheelhouse and quarter trim panels.
将三角板装饰伸展移至车轮罩板和三角饰板上。
Disconnect power. Wait 60 minutes before opening lamp housing
断开电源,等60分钟后再打开灯罩板.
Disengage the coaxial cable grommet from the hole in the right cowl side outer panel.
从右前罩板外侧孔切断同轴电线保护环。
Study the Related Characteristics of Cotton Web Cleaner on the Card Back Plate
梳棉机后罩板棉网清洁器有关特性的研究
The Lightweight Design of Bonnet in Auto-Body Based on Finite Element Method
基于有限元法的轿车发动机罩板轻量化设计
Remove the lamp from the hood inner panel.
由引擎罩内板将灯拆卸。
cover ,ironing-board of textile materials
烫衣板罩,纺织品制
cowl flap angle
整流罩鱼鳞板开启角
" Boots for self-locking nuts, singlelug, anchor"
GB/T939-1988单耳托板自锁螺母保护罩
" Boots for self-locking nuts,angle, anchor"
GB/T941-1988角形托板自锁螺母保护罩
" Boots for self-locking nuts,twolug, anchor"
GB/T940-1988双耳托板自锁螺母保护罩
Position the latch on the hood inner panel.
把锁闩定位在引擎罩内板上。
Remove the ash receiver from the instrument panel center bezel.
从仪表板中部玻璃罩拆下烟灰缸。
Application of Aluminum Foam Board in the Lathe Acoustical Enclusure;
泡沫铝板在机床隔声罩中的应用研究
Research of Batch Annealing Process for Cold Rolled Adding P High Strength IF Steel Plate
加磷高强IF钢冷轧板罩式退火工艺研究
Install the screw that attaches the latch to the hood inner panel.
安装把锁闩固定在引擎罩内板上的螺丝。
Install push-in fastener holding center of fascia to rear closure panel.
安装中心面板紧固到后罩盘上的推进式固定件。