Analysis of Gasket-selection for Driving Taper Assembly of Automobile s Driving Axle and the System Development;
汽车驱动桥主动锥齿轮总成选垫分析及系统实现
Research and Development on Fatigue Testing System of Gears in Drive-axle Assembly of Automobile;
汽车驱动桥总成齿轮疲劳测试系统的研发
Influences of hypoid gear quality on rear axle noise
螺旋锥齿轮质量对后桥总成噪声的影响
Bending stress analysis on gears of heavy duty automobile gear box based on assembly
基于总成的重型汽车变速箱齿轮弯曲应力分析
Research on Lubricating Oil Temperature Control Strategy of Gears in Drive-axle in Fatigue Testing System of Gears in Drive-axle Assembly of Vehicile
车辆驱动桥总成齿轮疲劳试验台中驱动桥齿轮润滑油油温控制策略的研究
Study on the Formation of Spur Face Gear Tooth Profile and Meshing Simulation;
直齿面齿轮齿面生成方法与啮合仿真
Research and Development on Fatigue Testing System of Gears in Drive-axle Assembly of Heavy-duty Trucks;
重型车辆驱动桥总成齿轮疲劳测试系统的研究与开发
straight-cut gear
直齿圆柱齿轮，正齿齿轮
burnishing of gear teeth
(齿轮的) 轮齿研磨
gear deburring and tooth pointing machine
齿轮去毛刺及齿顶成型机
Transformation from Rack-type Geer Cutter into Geer Hobber.
齿刀是怎么演变成齿轮滚刀的
Forming Mechanism of Tooth Flank Burr in Cutting Gear
齿轮齿形切削加工中的毛刺生成机理
Dynamic Simulation of the Generating Process of Gear Pofile;
齿轮齿廓范成过程的计算机动态仿真
Hot Forging Deformation of Magnesium Alloys AZ31B Spur Bevel Gear
镁合金AZ31B直齿锥齿轮热锻成形研究
Numerical Simulation on Precision Forging of Spiral Bevel Gears
弧齿锥齿轮精锻成形工艺的数值模拟
Research on Influence of Machining Parameters of Generating Method on Tooth Surface of Spiral Bevel Gear
展成法加工参数对弧齿锥齿轮齿面的影响研究
Study on Cold Extruding Forming Technology for the Driving Gear of Saw-tooth Inner Gear
锯齿形内齿主动齿轮冷挤压成型技术研究
Experiences from successful works have been summed up that the crux of improvement is the bearing design of the shaft supporting pulley and gear.
本文总结了成功的改造经验，指出改造中的关键问题是带轮－齿轮轴的支承设计。