A study on the batch method of thermal fixing for multiplexed photorefractive holograms;
光折变晶体中多重全息图分批定影热固定的研究
A Study of thermal fixing for multiplexed holograms;
多重全息图热固定的研究
The decay time of thermal fixing and the .
进行了Hf:Fe:LiNbO_3晶体全息图像热固定实验,加热温度为120℃,加热时间为40min,经过显影,在热定影实验中获得200h的无损读出结果。
In view of the defect of 《KWJ-Ⅲ》temperature controller in the application of hatching, improve it by utilizing simple the-delay circuit and fixed heater.
针对《KW—Ⅲ》型控温在孵化使用中存在的缺点利用简单的延时电路、固定加热器进行改进。
In this paper, the factors of affecting thermal fixing efficiency, and lifetimes of fixed gratings under both illumination and dark conditions are analyzed theoretically.
采用红光对单、双掺铌酸锂晶体中全息光栅的热固定效率及光擦除和暗存储寿命的特性进行了深入的实验研究。
On this basis, the batch thermal fixing technique was applied to holographic disk storage.
在此基础上,将分批热固定的方法应用于盘式体全息存储,分4批次存储了5000幅高分辨率图像,从而将存储面密度进一步提高到50 bits/μm2。
The batch thermal fixing scheme for multiplexed holograms is investigated.
研究光折变多重全息图分批热固定方法,依据热固定的基本理论模型研究离子补偿后的全息电子光栅在分批记录和定影过程中的光擦除特点。
Studies of Adiabatic Fixed-Bed Reactors (Ⅱ) Steady-State Temperature Profiles
绝热固定床反应器的研究——(Ⅱ)床内定态温度分布
stationary non-instantaneous electric water heater
固定非即热式电热水器
fixed tube sheet type heat exchanger
固定管板式热交换器
Test method for thermal conductivity of nonmetal solid materials by hot-wire method
GB/T10297-1998非金属固体材料导热系数的测定热线法
Numerical Analysis of the Thermal Stress Induced by Temperature Differences of Fixed Tube-Sheet Heat Exchangers
固定管板式换热器的温差热应力数值分析
testing method for thermal fixation properties of disperse dyes
分散染料的热固色率的测定方法
Copper sheets for fixing boards in heat exchangers
GB/T2531-1981热交换器固定板用黄铜板
Condenser-to-Radiator Mounting Brackets
冷凝器至散热器固定托架
Houdry adiabatic dehydrogenation process
胡得利固定床绝热催化脱氢过程
Determination of Total Acidity of solid Catalyst by Pyridine-Thermobalance Method
吡啶－热天平法测定催化剂固体总酸度
A Study of Temperature Gradient in Liquid Phase for Double-zone Heat Directional Solidification
双区加热定向凝固液相温度梯度研究
On the Gauge Fixing Yang-Mills Heat Flow and Related Problems;
规范固定Yang-Mills热流及相关问题研究
Analysis of Dynamic and Thermal Characteristics of Fixed Joint in Machine Tool;
机床固定结合面动态与热态特性分析
Finite Element Analysis on Stress of Fixedtube Sheet Heat Exchanger
固定管板式换热器应力的有限元分析
Research on Thermal Stability of Ti14 Alloy after Semi-Solid Deformation
Ti14合金半固态变形后热稳定性的研究
Study on Thermal Stability of Air Curing FEVE Coatings
常温固化FEVE氟碳涂料热稳定性研究
Kinetics of thermal imidization for a poly(amic-acid) in solid state with potentiometric titration
电位滴定法测定聚酰胺酸固相热环化动力学
In particular, the influences of the latent heat are more violent under moving laser beam action than under stationary laser beam.
另外，在移动热源作用下潜热的影响比固定热源更为突出。