The mechanical properties of notch bolt are tested under MoS2 dry-film lubrication and aviation lubricating-oil under pretightening force when we have brought torque to bear on notch bolt .
对MoS2干膜润滑和航空润滑油润滑的凹口螺栓进行了施加扭力时的预紧力测试,试验结果表明:施加相同扭力时MoS2干膜润滑凹口螺栓较航空润滑油润滑凹口螺栓的预紧力大,亦拧紧螺栓时施加较小的力矩可获得较大的预紧力,这是很有工程价值的现象。
The degree or angle of torsional stress.
扭力的强度，扭力的角度
The state of being twisted into a spiral;torsional stress or strain.
螺旋状，扭力扭成螺旋状；扭转的压力或张力
Testers work both clockwise and counterclockwise, so you can easily measure torque while tightening and loosening pieces.
扭力测试仪可顺时针或逆时针测量扭力，因此可方便地测量扭紧和扭松时的扭力。
Recommended flywheel bolt torques are:
飞轮螺栓的推荐扭力为：
The machanism is simple and robust because the strain gauge is directly attached to the torque detector.
结构简明、固，扭力仪直接与扭力测试部分相连。
Research On Dynamical Analysis Based On Torsional Condition Of Torsion Bar
基于扭力轴扭转状态下的动力学分析研究
The ATB bridge stops torsion completely due to basic" mechanical-laws".
抗扭桥的抗扭机能借助机械原理让拍子的抗扭力达到极致。
Install wheel on vehicle, and tighten to proper torque specification.
安装车轮至车体上，并且扭紧至正确扭力规格。
The analysis and calculation of mobile tortuous bar in pre-torturing process;
汽车悬挂扭力杆预扭强化的分析与计算
0 pressures, torques, pull dint, abnormal shape etc. precise spring coil.
0压力、扭力、拉力、异形等精密弹簧。
The Study of Changes in Femoral Stresses after Total Hip Arthroplasty and the Effect of Tersion;
THA前后股骨应力变化及扭力的影响
The analysis of fatigue for torsion shafts in the gearbox of wind turbine
风力发电机齿轮箱扭力轴的疲劳分析
To twist or turn suddenly and forcibly.
扭转猛然而有力地扭或转动
"TORQUETorque is twisting, or turning, effort, Torque, however, must not be confused with power."
扭矩:扭矩是旋转作用力或回转作用力。扭矩绝不能与功率相混淆。
Too much force will twist the key.
用力过猛会把钥匙扭弯。
Experimental Study on Prestressed Steel-HSC Composite Box Beams under Pure Torsion & Combined Bending and Torsion
预应力组合箱梁受扭与复合弯扭性能试验研究
Simulation of Abilities of Torsion Elimination and Ground Adhesion for Vehicle with New-Type Torsion-Eliminated Suspension
新型消扭悬架车辆的消扭能力及接地性仿真
Test study on the applying of pre-stressed anti-torsion steel bars in members under bending,shearing and trosion
弯剪扭构件采用预应力筋抗扭的实验研究