The survey of extension part and the design of locating bolt is the key for route adjusting survey.
测量定位引出件与定位销螺栓的设计是磁浮线轨道梁精调定位的关键。
Improved Design for Extension Part of Route Adjusting Survey
磁浮线轨道梁精调测量定位引出件与定位销螺栓的改进设计
elevator wrist pin keeper
升降机肘节销定位螺钉
Anchor/support bolt holes are located in base of body.
固定器/支架螺栓孔位于阀门的基座。
suction valve bolt and split pin
吸入阀螺栓及开尾销
bolt or cotter-pin drill
螺栓或开尾销孔钻头
Mounting Bolts (Screws)—IAC Motor
固定螺栓（螺丝）—IAC马达。
Position plate bracket and install attaching bolts through vehicle rear crossmember.
定位板托架并穿过车辆后横梁安装附接螺栓。
"The upper end rests against a flat washer, or spring retainer, which is attached to the valve stem by a retainer lock (also called a keeper)."
上端抵在弹簧座上,在弹簧座的下面用栓销(或叫做定位销)加以定位。
The Vanes are hold in place without pin, clamp or bolt, so it is able to be replaced and maintained quickly.
叶片不用销子、夹具和螺栓固定，更容易维修和更换。
Rear spring center bolt not in seat.
后弹簧中心螺栓不到位。
The bottom bolts will help locate gasket and hold it in position.
底部螺栓有助于对垫片进行定位,并保持恰当的位置。
square collar-head set-bolt
方头凸缘端紧定螺栓
Rear Mount To Body Bolts
后固定座与车身螺栓
LEFT ENGINE MOUNT BRACKET LOWER BOLTS
左引擎固定支架下螺栓
Remove caliper mounting bolts .
拆卸夹制器固定螺栓。
A thole pin.
桨栓固定桨位置的栓
When in place, the gasket should not extend beyond the end of the pipe( Fig.3).
为了如图1所示正确定位法兰，应该首先紧固两个锁定螺栓。
Position the shims and striker on the (GOP) and install the bolts.
把垫片和车门闩眼定位在风栅口面板上，然后开始安装螺栓。