Gauge length of filament is 10mm,25mm and 50 mm respectwely.
用环氧树脂将纤维粘结在纸夹中进行拉伸,标距分别为10mm,25mm和50mm。
Apply medium be apart from the original mark that the steel material of a specification district is tries the kind to unify the enactment on one fixed value of the provision,then mete out to gauge length after fracture to be apart from,make use of the Oliver to convert the formula conduct and actions.
应用中把一段规格区域内的钢材试样的原始标距统一设定在一规定的固定值上(即统一标距),然后量出断后标距,利用 Oliver 换算公式作为转换工具进行伸长率换算,通过计算机的便捷性换算得出符合标准要求的断后伸长率。
First,the original gauge distance of the steel are delineated as constant,then the gauge length after fracturing are measured.
实际应用中将钢材试样的原始标距设为一固定值,然后测量断后标距,利用Oliver换算公式作为转换工具,通过计算机的便捷性换算得出符合标准要求的断后伸长率。
Through the analysis of factors which will effect breaking location of tensile testing of helical welding pipe,this article indicates breakpoint of tensile test shall locate in middle of sample gauge length,and also introduce the method to avoid breakpoint deviating the middle of gauge length.
通过对影响螺旋焊管拉伸试样断裂位置因素的分析,指出拉伸试样断裂点应位于试样标距中间,并介绍了试验中避免断裂点偏移标距中间的方法。
Measures to reduce beneficiation index difference between No.1 and No.2 shops of Qidashan Beneficiation Plant;
对齐大山选矿厂两选指标差距的探讨
Study of the microwave OTH radar maximum detection range of ships
微波超视距雷达对海面舰船目标距离的探测
macro teleconverter
增距式微距附加镜﹝使标准镜头变成微距而保留最近封焦距离﹞
fixed-range mark generator
固定距离标记发生器
DME ground beacon antenna
测距装置地面信标天线
LTMR (Laser Target Marker/Ranger)
激光目标识别器/测距器
MOPTAR (MultipleObjectPhaseTracking and Ranging)
多目标相位跟踪和测距
standard pitch roller chain
标准节距套筒滚子链
One mile to target.
距离目标还有一英哩。
outer-marker crossing height
通过远距信标台的高度
Resistance Distance and Kirchhoff Index in Graphs;
图的电阻距离和Kirchhoff指标
LRMTS (Laser Ranger and Marked-Target Seeker)
激光测距器与标识目标自导导弹
The road sign said Westwood was four miles away.
路标标出威斯特伍德距此4英里远。
marker radio beacon
无线电信标近距离)无线电指位标
To set margins, drag the margin boundaries on the rulers.
通过拖动标尺上的页边距界线，可以设置页边距。
Note: The maximum range was reset to18 which is the distance to the selected target.
注意：最大距离被重新设置为18，这是目标的距离。
Research about Blasting Vibration Speed of Long Distance Little Space Tunnel;
长距离小净距隧道爆破开挖振动标准的研究
New Calibration Method of Principal Distance of Star Sensors Through Diagonal Distance
利用星角距对星敏感器主距进行标定的新方法
Accurate Distance Setting about Distance Marker of Road
公路地点距离标志中距离的准确设置研究