The failure cause of steering shaft of the minitype tractor was analyzed.
对小型拖拉机转向轴早期出现的断裂原因进行了分析。
The forming process of steering shaft was analyzed,the manufacturing procedure of the part was determined.
对转向轴零件进行了工艺分析,制定了工艺路线。
First,the design axle steering angle was obtained from the simulation,then ADAMS/Insight was used to reduce the axle steering angle to zero,to optimize variable rear suspension links hardpoints,and to improve vehicle operational stability.
先求出影响整车操纵稳定性的后桥轴转向角的初始值,然后利用ADAMS软件Insight模块,以轴转向角趋近于0为目标,以后悬架杆件控制点的坐标为变量进行优化设计,得到控制点的坐标值,使整车操纵稳定性得到改善。
The steering wheel is mounted on a steering shaft that extends into the steering gear.
转向盘安装在转向轴上,转向轴延伸至转向器。
"Essentially, the steering gear consists of two parts, a worm on the end of the steering shaft and a pitmanarm shaft on which there is a gear sector, toothed roller, or stud."
转向器基本上由两部分组成:装在转向轴末端的蜗杆和转向摇臂轴。
counter crankshaft rotation
反曲轴转动方向的转动
Most Bearings support rotating shafts against either transverse (radial) or thrust (axial) loads.
大多数轴承都支承径向或轴向负荷的转轴。
side bearing arch
中摇枕(三轴转向架)
center bearing anchor bar
中摇枕拱板(三轴转向架)
tube and ball type steering column
球轴承套管式转向管柱
steering clutch release crank axle
转向离合器开关曲柄轴
steering knuckle bearing grease nipple
润滑转向节轴承油嘴
Steering Knuckle Separation From Driveshaft
转向关节与驱动轴分离
swash plate axial piston pump
旋转斜盘轴向活塞泵
Column shaft coupler binding.
转向柱轴接合器过紧。
steering worm sector bearing
转向器扇形蜗轮轴承
Install steering damper onto the axle bracket and drag link.
安装转向阻尼器至轴支架和转向拉杆。
Research on Dynamic Steering Control Strategy of Multi-steering Vehicle
多轴转向车辆动态转向控制策略研究
"The driving shaft causes the spider to rotate, and the other two trunnions of the spider cause the driven shaft to rotate."
主动轴使万向节十字轴转动,另外两个万向节十字头使从动轴转动。
Radial Measurement on the Axial Displacement of AMB Rotor;
电磁轴承转子轴向位移的径向测量研究
Research on Bending Rotation Test of Rotation Shaft in Point the Bit Rotary Steerable System
指向式旋转导向系统旋转轴弯曲旋转试验研究