Embedded system software pouring is a technology for software module in embedded system using on system programming memory and this memory can be written-in by external devices if embedded system need software upgraded.
嵌入式系统软件注入是指将嵌入式系统中的软件模块使用在线可编程存储器存储,可在需要时通过外部设备注入的技术。
Research of Technology for Software Pouring Based on Embedded System;
基于嵌入式系统的软件注入技术研究
Research of Software Fault Injection and Software Vulnerabilities Identifying
软件故障注入及软件脆弱点检测方法研究
Research on Fault Injection of Control and Monitor Program of Synthetic Aperture Radar;
星载SAR控制软件故障注入技术研究
Research of Fault Injection Software for Unmanned Aerial Vehicles Based on Linux
基于Linux的无人机故障注入软件研究
Design of the Large Tilt Ion Implanter Control System Software
大角度离子注入机控制系统软件设计
The Research and Implementation of a Robustness Evaluation Method Based on Event Injection
基于事件注入的面向应用的软件健壮性评测
Research about Distributed Software Fault Injection and Software Vulnerabilities Identifying;
分布式软件故障注入及软件脆弱点检测方法研究
Inject Fault to Test Safety-critical Software Using Scrip
使用基于脚本的故障注入测试安全苛求软件
Based on Fault Model s Research on Software Fault Injection Method;
基于故障模型的软件故障注入方法研究
Research on Fault Injection of COTS-based Safety-Critical Software System;
基于COTS的安全关键软件故障注入技术研究
Research on Software Security Testing Based on the Fault Injection
基于故障注入的软件安全测试技术研究
Research of Fault Injection and Analysis System for Unmanned Aerial Vehicle Based on Linux;
基于Linux下的无人机软件故障注入与分析系统研究
System Robustness Testing Based on Swifi
基于软件实现的故障注入的系统健壮性测试研究
The Software Industry Should Pay Attention to the Development of the Profession Software;
软件产业的发展要注重行业软件的开发
Patching helps eliminate software flaws that can be used to inject malicious kernel code.
打补丁有助于消除软件缺陷，这些缺陷可能会被用来注入恶意内核代码。
Note: You must enter a valid customization code in order to have the ability to generate a custom package. Otherwise the wizard will run in demo mode.
注意: 要生成自定义软件包，必须输入有效的自定义代码。否则，向导将在演示模式下运行。
Research on Software Reuse on Avionics Software Testing Field
软件复用在航空嵌入式软件测试中的应用研究
Formal Analysis and Verification for Component-based Embedded Software Designs;
构件化嵌入式软件设计的分析与验证