As the existing models are insufficient to accurately describe the mechanism, a comprehensive model is advanced in this paper to evaluate the relative static pressure and driving force of the solar chimney power plant systems, in which the effects of various parameters on the relative static pressure and driving force have been further investigated.
由于现有模型不足以准确描述太阳能热气流发电系统的物理机制,本文提出一个更完善的数学模型去分析太阳能热气流电站系统的相对压力分布和系统抽力。
The results show that the appropriate off-gas pressures in the periods of emerged arc and submerged arc are -200-250 Pa and -120 Pa, respectively.
结果表明:露弧加热期和埋弧加热期炉盖的合理抽气压力分别为-200~-250Pa和-120Pa;底吹氩气量过小不能在液面上部弥散,而增大到20~50m3。
In the heating period of emerged arc, appropriate off-gas pressure is more than 250 Pa and high temperature zones in the middle of lid is big.
结果表明,进入炉盖内的气体在主体部分流动规律是一致,露弧加热时达到硝烟除尘要求的合理抽气压力为250 Pa 以上,炉盖中部局部高温区域大温度高,埋弧加热期合理抽气压力为200 Pa 左右,炉盖壁面温度低得多,中部温度高温区仅为330 K(57℃)左右。
The results showed that the t_(10)and t_(90)of rubber compound extended a little by using superfine active kaolin partly instead of carbon black in inner ply and outer ply compounds,and the physical properties of vulcanizate and H pull-out after aging changed little;the endu-rance of finished tire improved and the cost of rubber compound reduced.
结果表明,在内层和外层帘布胶中以超细活性高岭土部分替代炭黑后,胶料的t10和t90稍有延长,硫化胶的物理性能及老化后H抽出力基本相当;成品轮胎耐久性能提高,胶料成本降低。
The results showed that the scorch time extended,the curing speed reduced,the anti-reversion improved,and the better tensile,elongation and tear properties were obtained using TBSI instead of TBBS by equal weight in the upper bead filler compound;and the scorch time extended,t_(90) reduced,the permanent tensile set decreased and the H pull-out changed little using 1 phr of TBSI instead of 1.
在胎体胶配方中以 1份促进剂TBSI替代 1 2 5份促进剂DZ ,胶料的焦烧时间延长 ,t90 缩短 ,硫化胶的拉断永久变形减小 ,H抽出力相当。
The results showed that when compared to the dry cobalt decanoate,the wet cobalt decanoate gave NR vulcanizate higher H pull-out force,lower H pull-out force loss after hot air aging and brine aging and similar physical properties.
结果表明,与干法工艺生产的癸酸钴相比,采用湿法工艺生产的癸酸钴可提高NR硫化胶的H抽出力,经热空气老化和盐水老化后硫化胶的H抽出力下降率较小,其它物理性能基本相当。
It also states modifying formula of the taking out force and compares calculation examples.
本文提出了在塑料注射模中斜导柱侧向分型与抽芯机构抽拔力的计算时,应按侧型芯滑块在侧向分型方向的垂直面的投影面积计算,并给出了抽拔力计算的修正公式并通过计算实例比较证明该公式的合理性。
Low ultimate pressure, high pumping speed for Ar.
极限压力低、抽气压力范围宽，对氩气抽速较高。
Vacuum Pumping System for Cabin Pressure Regulator Dynamic State Test Stand
座舱压力调节器动态试验台真空抽气系统
double-extraction non-condensing turbine
双抽气背压式汽轮机
non-condensing automatic extraction turbine
背压调节抽气式汽轮机
draw-down bottom pressure curve
抽汲期间井底压力曲线
Engeering Design and Pressure Distribute Analysis for the Cryopumping System of Neutral Beam Injection System;
中性束注入系统低温抽气系统的工程设计及压力分布研究
Air pressure is measured by a barometer.
空气压力用气压计度量。
a manometer for measuring vapor pressure.
测量气体压力的压力计。
Development of a triaxial gear-type nitrogen compressor with intermediate exhaust
中间抽气型三轴齿轮式氮压机的研发
As the name suggests, liposuction relies on vacuum pressure to draw out the lipids.
顾名思义，抽脂利用真空压力来抽出脂肪。
pneumatic and hydraulic pressure regulator
气动及水压压力调节器
discharge pressure
（气压机的）排放压力
Result Analysis of Random Inspection of 110kV Power Transformer Quality;
110kV电力变压器产品质量抽检结果分析
Pressure Derivative Type Curves of Swabbing Well in Heterogeneous Oil Reservoir
非均质油藏抽汲井压力导数典型曲线
air brake reservoir pressrue indicator
气制动贮气筒压力表
air at a pressure greater than that of the atmosphere.
承受的压力比大气压力大的空气。
I have no cramps and I feel strong.
我的手脚不会抽筋，我有的是力气。
The Aerodynamic/Structure Design of Subsonic Aspirated Compressor Cascade;
亚声速附面层抽吸式扩压叶栅气动/结构设计