Microstructure transformation of ultrafine eutectoid lamellar under deformation of shear strain;
剪切应变模式下超细共析片层组织演变研究
Shear strain in MBE grown CdTe films on Si(211) substrates;
在Si(211)衬底上分子束外延CdTe的剪切应变
The model of plastic shear strain gradient on size effect in uniaxial compression of rock specimen;
岩石试件尺寸效应的塑性剪切应变梯度模型
The approximate formula of the changing value of wall thickness of the inner and outer side of the tube and the formula of the tangential strain are presented,which may be applied to practical production after amending.
通过大量管材弯曲试验,分析了沿弯曲线的切向和管壁厚方向的应力应变状态,给出弯管内、外侧管壁厚变化量和切向应变的近似计算公式。
It was found that during the no_mandrel bending forming process of minor diameter tube,the actual tangential strain along pipeline direction was approximately distributed in parabola,and the maximum strain appeared around the intermediate section of the bending angle.
作为管材弯曲变形机理实验研究的一部分,通过大量实验结果证明了小直径管无芯弯曲成形过程中,沿管线方向的真实切向应变近似呈抛物线形分布,最大应变产生在弯曲角中部附近。
Analyses of Shearing Strain Characteristic and Microstructure on Semi-Solid ZA27 Alloy;
半固态ZA27合金剪切应变特征与显微组织分析
Its sensing part is a thin yielding cylinder on which eight holes are opened at two levels,so the shear stress can be gained in three axes.
采用一种特殊结构的弹性体元件,实现了三维加速度量都利用剪切应变测量。
On the same level, so the arrangement allows convenient gaining of shear stress in each of the axes.
该传感器为电阻应变式 ,采用了薄壁圆筒上开双层错位孔形式的弹性元件 ,从而实现了三维加速度量都利用剪切应变测量。
A novel flow model was designed and morphological changes of endothelial cells could be seen obserwed in this mode at high or low shear stress regions produced by different flow patterns in areas with accelerated of stagnated flow velocity in a chamber.
在此模型的不同区域内不同的液体流动状态下，可产生高低不同的切变应力。
Analyses of the Constant Shear Strain Point and Velocity Distribution in the Shear Band for Geomaterials
地质体材料剪切带内部的常剪切应变点及速度分布分析
New Method for Calculating Local Shear Strain in Adiabatic Shear Band of Titanium Alloy
钛合金绝热剪切带的局部剪切应变估算的新方法
(Numerical) Simulation of Shear Strain Localization Processes along Circular Tunnels with Different Diameters
不同尺寸的圆形隧洞剪切应变局部化过程模拟
strain controlled direct shear apparatus
应变控制式直接剪切仪
uniform strain shearing strengh tester
等应变剪切强度测试仪
The adiabatic shear bands of U-5.7Nb at high strain rate
高应变率下U-5.7Nb合金的绝热剪切变形
Analysis of Shear Deflection of Flat Steel Box Girder of Cable-Stayed Bridge;
斜拉桥扁平钢箱梁剪切变形效应分析
The only strain is a shear strain and the dilatation is zero, these waves are called shear waves.
唯一的应变是剪应变而没有膨胀，这种波叫剪切波。
Cyclic Stress History Effects on Small-strain Shear Modulus of Silt;
循环应力历史对粉土小应变剪切模量的影响
Effect of stress path circumgyration on shear modulus under small strain
小应变条件下应力路径旋转对剪切模量影响
Theoretical Analysis of the Adiabatic Shear Band Width and Strain Rate Effect of Ti-6Al-4V
Ti-6Al-4V绝热剪切带的厚度及应变率效应研究
The residual strain is the additional shear strain created with the increase of pore pressure due to cyclic shear under initial shear stress.
残余应变是由于周期剪切引起孔隙压力增长,在初始剪力作用下产生的附加的剪应变.
Experimental study on shearing deformation behavior of saturated clay under cyclic stress
循环应力下饱和黏土剪切变形特性试验研究
Research on the Prediction for Shear Yield Stress of Electrorheological Fluids;
电流变液剪切屈服应力预测的理论研究
Application of Mitsubishi Inverter Remote Control Function in PC Shear for Bar Steel
三菱变频器遥控功能在PC钢棒剪切机中的应用
STUDY ON SHEAR CREEP AND ROUGHNESS EFFECT ON HARD DISCONTINUITIES OF MARBLE
大理岩硬性结构面剪切蠕变及粗糙度效应研究
Key rock strata effecting analysis on surface borehole shear deformation fracture
地面抽采钻井剪切变形破坏的关键层影响效应
The analysis covers plane strain, plane stress and anti-plane strain shear cases.
分析包括了平面应变、面应力和出平面应变剪切三种情况。