This article introduces the design of louver tooling for turret punch press, mainly focusing on the design and calculation of die, punch body and stripper plate.
介绍了多工位数控冲床用百页窗模具的设计，重点介绍了下装凸模、上装镶拼凹模及卸料板的设计和计算方法。
knockout actuated stripper
打料机构带动的卸料板
Skill of Punch & Die and Inner Ejector & Outer Stripper Simultaneously to Process
线切割凸凹模同时加工及一次性加工内外卸料板技巧
Remove the access cover( s) and fold the insulation outward and away from the thermostat( s). Do not remove the plastic cover.
拆卸观察盖板和温控器外部的绝缘保温层。不要拆卸塑料盖。
When discharging, the motor operates, hydraulic cylinder charges pressure, push rod (piston rod) draw back, the valve plate connected with push rod opens, the materials are discharged.
当需要卸料时，电机运转，液压缸增压，推杆（活塞杆）收回，和推杆连接的阀板开启，物料卸下。
Instead, the motor rotate reversely, push rod (piston rod) push out, the valve plate closes, stops discharging.
反之，电机反转，推杆（活塞杆）推出，阀板关闭，停止卸料。
When the moment made by material on turning plate is greater than that of heavy hammer and rocker, the disc will open adown to discharge.
当作用于翻板上的物料产生的力矩大于重锤摇杆产生的力矩时，阀板打开向下卸灰。
Research on the Disassembling Methods and Force for Electronic Components on PCBs
电路板元器件拆卸方法及拆卸力研究
Remove the lamp from the hood inner panel.
由引擎罩内板将灯拆卸。
Remove B-pillar upper trim panel.
拆卸B-柱上部饰板。
Remove the trim panel from the front door.
从前车门上拆卸饰板。
compression refuse collector
旋转板自装卸垃圾车
Remove upper fixed column shrou
拆卸上部固定柱围板。
Remove the door module from the trim panel.
从饰板上拆卸车门模组。
Instrument Panel End Cap Remove/Install
仪表板端盖拆卸/安装
Instrument Panel Top Cover Remove/Install
仪表板上盖的拆卸/安装
Remove quarter panel trim extension.
拆卸三角板装饰伸展。
inertial discharge centrifuge
惯性卸料离心脱水机
bottom-dumping hopper body truck
底卸料斗式运货汽车