Effects of concentration of Al2O3in the electrolyte,the current density and the electrolyte s jet velocity on nano-Al2O3 contents were analyzed.
利用喷射电沉积工艺制备了Cu-A l2O3纳米复合铸层,分析了纳米A l2O3颗粒添加量,阴极电流密度以及电铸液喷射速度对复合电铸层中纳米颗粒复合量的影响,采用扫描电镜(SEM)及其附带的能谱仪(EDS)对复合电铸层的微观形貌和铸层成分进行了分析,研究了复合电铸层中纳米颗粒复合量对其显微硬度的影响。
Direct Measurement of Jet Velocity Utilizing CCD Technology
采用电荷耦合器件对喷浆速度进行直接测量
Simultaneous and Rapid Determination of Aciclovir, Ganciclovir and Penciclovir in Plasma Using Solid-phase Extraction and High-performance Liquid Chromatography;
SPE-HPLC法同时快速测定血浆中更昔洛韦、阿昔洛韦和喷昔洛韦的浓度
Discussion on the relationships between the injection duration of pulp and the aeration velocity and the entrained-air volume
矿浆喷射量与充气速度和空气吸入量的关系探讨
outlet triangle
喷嘴出口速度三角图
Research about Nozzle Discharge Speed Distribution for Meltblown Model
熔喷模头喷嘴孔流场速度分布的研究
Study on Minimum Spouting Velocity in Liquid and Solid Bed with Draft Tube
带导流管液固喷动床的最小喷动速度研究
The desirability of providing a high hydrogen injection velocity and a low oxygen injection velocity has been previously discussed.
上面已经讨论过，希望能够提供高的氢喷射速度和低的氧喷射速度。
Slurry Circulating Velocity in an External-Loop Slurry Reactor
外环流浆态床反应器浆液循环速度的研究
The Humidity Effect on the Discharge Coefficient of Sonic Nozzles
湿度对音速喷嘴流出系数影响的研究
Effect of velocity ratio on combustion process gas-gas injector
速度比对气-气喷嘴燃烧性能的影响
Estimation Method of Nozzle Exit Speed for Torpedo Turbine Engine
涡轮发动机喷管出口速度的估计方法
Effect of extrusion speed on formation of nascent PAN hollow fiber
喷丝速度对PAN中空纤维成形的影响
Such high-speed jet aircraft have a speed of 700m.p.h.
这样高速喷气式飞机的速度为700英里/小时。
High temperature instantaneous supersonic flow measurement using hydroxyl tagging velocimetry
高温瞬态超音速喷流OH分子示踪速度测量
Pulp--Determination of stock concentration--Rapid method
GB/T5399-1985纸浆浓度的测定快速法
Study on the Deposit Velocity of Settling Slurry in Horizontal Pipeline;
沉降性浆体水平管道堆积速度的研究
Fully accelerating abrasive particle velocity to near water-jet velocity is main aid of nozzle design.
喷嘴设计的主要任务就是要使从喷嘴喷出的磨料粒子得到充分加速,以便接近水射流的速度.
Due to the high concentration and high viscosity of the CWS, bad atomizing properties and bad wearproof ability are much serious problems all along.
水煤浆浓度高、粘度大，雾化困难和磨损严重是水煤浆喷嘴需要克服的两个难题。