Effect of fatigue on peeling performances of calendered flexible composites reinforced with weaving fabrics;
疲劳对机织压延类柔性复合材料剥离性能的影响
Conclusion is made that the yarn counts, fabric density and PVC film thickness affect the tearing and peeling performances.
对机织物增强压延柔性复合材料进行撕裂、剥离性能测试分析,得出基布的纱线线密度、织物密度以及涂层厚度与撕裂强力、剥离强力之间的关系,并对经纬向撕裂强力和剥离强力的关系进行初步研究。
Research progress of the removability of pressure-sensitive adhesive(tape);
压敏胶(带)的可剥离性能的研究进展
on plating rate,anti wear property and anti stripping property were studied.
探讨了铅、锰、镍、锌、钙、锶等金属离子及铵离子对镀速和镀层耐磨损性能、耐剥离性能的影响。
The test results showed that the 5231/823 prepregs made by the two methods mentioned above individually were about equal in the processing properties and the climbing drum roll peel properties.
着重研究了用溶液法和热熔胶膜法工艺所制备的5231/823玻璃布预浸料的物理性能、工艺性能、力学性能和滚筒剥离性能,旨在探讨不同预浸工艺对预浸料及其复合材料性能的影响,试验结果表明:这2种工艺所制的5231/823预浸料的工艺性能和剥离性能相当,但在预浸料树脂含量控制精度方面,热熔法工艺高于溶液法工艺;在预浸料挥发分方面,热熔法工艺的较低,一般低于0。
Three major theories elucidating dough stickiness were highlighted,including peeling energy theory,pressuresensitive adhesive(PSA) theory,and Hoseney theory.
作者综述了面团体系表面胶粘性的流变学机理和相应的表征方法及影响因素,着重介绍了关于面团表面胶粘性的剥离能理论、压力敏感型胶粘剂(PSA)理论和Hoseney理论,并讨论了其相应的表征方法,包括剥离法、动力机械流变法、表面张力法和探头法。
Chemistry Design of Spalling-Resistant Wheel Steels and the Effect of Si Addition on Spalling Resistance
抗剥离车轮钢的合金设计及Si元素对抗剥离性能的影响
Experimental Study on Shear Behavior and Behavior at Elevated Temperature of RC Beams Strengthened with High-performance Ferrocement;
HPF加固RC梁抗剪剥离性能及高温性能试验研究
Experimental Study on the Peeling Capability of Steel Plate Strengthened with Carbon Fiber Reinforced Plastics;
CFRP粘结钢板复合构件的剥离性能试验研究
Oxide scale formation on high-carbon steel and its mechanical descaling property
高碳钢氧化皮的形成及其机械剥离性能
Studies on Cathodic Disbondment of Base Coatings for Ambient Curable Fluoro-carbon Coating;
常温固化含氟涂料配套底涂料耐阴极剥离性能的研究
Effect of Exfoliation on Properties of α-ZrP/PANi
剥离剂对磷酸锆掺杂聚苯胺材料性能的影响
Preparation of strippable protection coating for lens
可剥离光学仪器镜头防护膜制备及性能分析
Exfoliation and photocatalytic activity of layered K-Fe-Ti oxide
层状K-Fe-Ti氧化物的剥离及光催化性能
Research on the property and synthesis of compound adhesive mud remover and bactericide
复合粘泥剥离杀菌剂的合成及其性能研究
Technological Properties and the Peeling Ability of Water-base Bauxite Coating for EPC(Expandable Pattern Casting)
水基铝矾土消失模涂料工艺性能及易剥离性的研究
Studies on Flexural Behavior and Debonding Mechanism of RC Beams FRP-Strengthened at Different Preloaded States;
FRP加固负载混凝土梁的抗弯性能及剥离行为研究
Study on Flexural Behavior and Debonding Failure of CFRP-strengthened RC Beams;
碳纤维片材加固钢筋混凝土梁抗弯性能与剥离破坏研究
Polyproplene Nanocomposites Via Melt Intercalation:Formation,Exfoliation,Morphology and Property;
熔体插层聚丙烯纳米复合材料：形成过程、剥离机理、形态与性能
Affects to the fiber and fabrics performance of the extent of ultra-fine wool scales that peeled off
超细羊毛鳞片剥离程度对纤维及织物性能的影响
Study on Influence of Hydrophilic Modification of TiO_2 Powder on Film Performance of Strippable Coatings
TiO_2粉体亲水处理及对可剥离涂料膜体性能影响的研究
The Preparation of Epoxy Nanocomposites with Highly Exfoliated Montmorillonite and Its Properties
高度剥离型环氧树脂/蒙脱土纳米复合材料的制备与性能
Exfoliation of the lens capsule may be either true exfoliation or pseudoexfoliation.
水晶体囊之层状剥落可能为真性层状剥落或假性层状剥落。
after exploration has determined that the deposit can be mined from the surface, the overburden must be stripped off first. Different stripping methods are used according to the nature of the material to be removed.
在探明了矿床可露天开采后，首先必须剥离覆盖层。根据剥离物的性质，可采用不同的剥离方法。