Sintering of corundum-silicon nitride composites in air atmosphere;
空气气氛中烧成刚玉-氮化硅复合材料的研究
A new technology for piezo acoustic ceramic disk——one sintering without isolating powder;
压电电声陶瓷片的无垫粉叠层一次烧成
The article,on the basis of making piezoelectric ceramic materials mixed with PZT,gets the best sintering condition of the material,which has reached or exceeded the level of piezoelectric ignition materials,although there being still potentials to be tapped with proper technology,and also introduces its development.
在介绍掺杂PZT压电陶瓷材料制备基础上总结出生产掺杂PZT材料的最佳烧成条件。
Reductive Firing Technique of Ceramic Products;
陶瓷制品的还原烧成技术
Effect of firing temperature on strength of vitrified high speed grinding wheel;
探讨烧成温度制度对陶瓷结合剂高速砂轮强度的影响
This paper studied the high firing temperature condition of modified porous zeolite pellet and gave the quality evaluation of the product,which had both good exchange adsorption ability and high compressive resistance.
研究了多孔改性沸石球形颗粒的高温烧成制备方法,主要考察质量配比、烧制温度、烧制时间对氨氮去除率的影响,从而确定最佳制备条件,并测定产品物理性能,使之同时具有较高的吸附交换能力和抗压强度。
Fe 2O 3?Cr 2O 3?MnO 2 contributed to sulfo aluminate minerals clinkering.
采用电预热然后用微波加热二次加热方法 ,快速烧成了 Ca4 Al6 SO1 6 ,Ca3Sr Al6 SO1 6 ,Ca3Ba Al6 SO1 6 等硫铝酸盐矿物。
The feasibility of replacing iron powder with copper-mine tails in clinkering of silicate cement was discussed is the paper.
本文研究了用铜尾矿代替铁粉煅烧硅酸盐水泥的可行性；探讨了铜尾矿中微量元素对易烧性的影响；确定了铜尾矿煅烧的适宜烧成工艺。
We can solve completely the problem of warpage and achieve a good burning result by changing fume aerator,improving flue pipe,increasing bag wall and board flash,assembying two rooms of furnace again and lengthening preheating zone and so on to cut down too high burning barotropy and improve the state of air scattering and the oxidizing result of preheating .
通过更换排烟风机，改进排烟管路，增加挡火墙、挡火板，加装两节窑炉延长预热带等改进措施以达到降低过大的烧成正压，改善窑内气流分布状态，强化预热期氧化效果之目的，彻底解决了上翘问题，取得了比较理想的烧成效果。