Study on Tilt Pouring Craft of Sand Mould for Al-Si Alloy
铝硅合金用砂型模具的倾转浇注工艺研究
Technology of Inclined Cast Avoid Appeared the Defects of Misrun in Oven Door Casting
倾斜浇注防止焦炉炉门铸件产生浇不足缺陷
A new casting technology for inlet manifold in tilt casting machine for gravity die casting was described.
介绍了在可倾式金属型浇注机上制造进气歧管的铸造新工艺。
Then the liquild-surface in the case is decided by the matching relation of the flow of the leaning stove and the roll-casting speed 。
在实验铸轧系统中,前箱液位由倾动式电炉的浇注流量与铸轧速度的匹配关系决定。
At the same casting speed, the eddy center is the lowest if the pouring angle is about 60° and the penetrating depth of molten steel flow increases with the increasing pouring angle.
在相同的拉坯速度下，随着浇注倾角的增大，钢液流股的穿透深度也随之增大。
Pour a solid foundation of cement
浇注坚实的水泥地基
concreting boom
浇注混凝土起重机臂
connecting rod babbitting jig
连杆巴氏合金浇注器
connecting rod bearing pouring
连杆轴承巴氏合金浇注
A mold for the setting of concrete.
模板浇注混凝土的模板
"If the placing Boom is swiveled 180 degrees from the Basic position to the rear, the end hose can reach every point of the roadway surface being concreted. "
如果布料机臂旋转180度从前面旋转到后面,软管末端能伸到要浇注混凝土路面板的任一处。
Cast Process of Winding in Epoxy Resin Cast Dry-Type Transformer
环氧树脂浇注干式变压器的绕组浇注工艺
We were drenched by a sudden downpour
突如其来的倾盆大雨把我们浇透了。
The rain came pelting down.
倾盆大雨劈头盖脸地浇了下来。
The Secondary Development of Autocad for Feed System of Injection Mold;
注塑模浇注系统的AutoCAD二次开发
Design of Injection Mold Gating System of the Plastic Gear Based on MoldFlow Software
基于MoldFlow塑料齿轮注射模浇注系统设计
The Design and CAE Analysis in Multy-carities Injection Moding Feed System
多型腔注塑模浇注系统设计及CAE分析
tilting position
倾斜角(转炉)，倾斜位置