The purpose of weld guide bending test is to detect plasticity of welding joint,welding process and surface defects of materials.
焊缝导向弯曲试验的目的是检查焊接接头的完好性和塑性以及材料的焊接工艺和表面缺陷。
Figure 3, 4 shows a flat piece of metal that has been through an angle of 180. Sheet metal may be given a single bend test
图3．4表示一片金属扁试样被弯曲180°可以对薄板金属进行单向弯曲试验，
Test methods for bare wires--Bend test--Single bend test
GB/T4909.6-1985裸电线试验方法弯曲试验单向弯曲
alternative wrap around guided-bend test
交变缠绕定向弯曲试验
Test method for flexural properties of unidirectional fiber reinforced plastics
GB/T3356-1999单向纤维增强塑料弯曲性能试验方法
Research on Bending Rotation Test of Rotation Shaft in Point the Bit Rotary Steerable System
指向式旋转导向系统旋转轴弯曲旋转试验研究
fine ceramics(advanced ceramics, advanced technical ceramics)-test method for flexural strength of monolithic ceramics at elevated temperature
细陶瓷-单块陶瓷高温弯曲强度试验方法
flexing ozone weather testing chamber
臭氧腐蚀弯曲试验箱
testing method for flexing endurance of light leathers and their surface finishes
皮革耐弯曲性试验方法
testing method for flexural creep of plastics
塑料弯曲蠕变试验法
rotary bending tester
旋转弯曲疲劳试验机
rotating bending fatigue machine
回转弯曲疲劳试验机
reversed bending fatigue machine
反复弯曲疲劳试验机
Test methods for bare wires--Bend test--Reverse bend test
GB/T4909.5-1985裸电线试验方法弯曲试验反复弯曲
With data obtained from low temperature bending and bending creep test, a simple calculation method is given for calculating rupture energy.
应用低温弯曲和弯曲蠕变试验所得数据,给出了破坏能的简单计算方法。
Methods of test for enamelled wires--Mandrel winding test for rectangular wires
GB/T4074.7-1983漆包线试验方法扁线弯曲试验
fine ceramics(advanced ceramics, advanced technical ceramics)-determination of fracture toughness of monolithic ceramics at room temperature by the surface crack in flexure(scf) method
细陶瓷-单块陶瓷常温断裂韧度试验方法-弯曲表面龟裂法
Plastics--Determination of flexural properties by use of small specimens
GB/T16419-1996塑料弯曲性能小试样试验方法
INFLUENCE OF HOLE POSITION ON BENDING RIGIDITY OF UD-LAMINATE
穿孔位置对单向层板弯曲刚度的影响